How to Get Hair Out of Sink Drain
Hair is one of the most common culprits that cause the bathtub drain to back up or your shower drain to clog up. It is almost certain that everyone has encountered a hair clog at some point during their lifetime.
Drain stoppers will not stop long and short hair from finding their way down the drain and clogging the pipes. If that happens, I am here to help you out.
In this article I will explain how to get hair out of the sink drain.
Frequently, people use harsh chemical drain cleaners in order to clear clogged drains. On the other hand, many of these products can cause damage to your pipes over time as they are caustic.
There are people who call a plumber immediately, which causes them to spend a great deal of money. Fortunately, there are a number of affordable and easy ways to get hair out of a sink drain.
Fortunately, hair clogs can often be fixed without expensive or complicated solutions, unlike other more serious clogs.
You can use these 8 ways to unclog your shower drain or sink drain.
How to Get Hair Out of Sink Drain – 8 Best Methods
1. Baking soda and vinegar
The combination of baking soda and vinegar is very effective in removing nasty hair clogs, so it takes very small effort.
The baking soda not only has the ability to dissolve the hair in your drain, but also has the ability to disinfect the drain.
This will ensure that fungi and bacteria are not growing in it. Here’s how to get hair out of sink drain with baking soda & vinegar:
- One cup of baking soda and one cup of vinegar should be poured into the blocked drain. A chemical reaction will occur, which causes the drain to fizz.
- One liter of boiling water should be poured into the drain about 10 minutes after the fizzing stops.
- Make sure that the water is flowing smoothly by turning on the faucet.
- Retry the first three steps if there is still a problem with the drain.
- In some cases, you may need to repeat the process multiple times to loosen stubborn clumps of hair.
2. Needle-Nose pliers
First of all, go and check your drain cover. See whether it is removable or not. If you are lucky enough to have a removable cover on your drain, using pliers or a wire hanger may be an option.
This will enable you to get the hair out at the end. Below is a list of materials required to complete this method.
- a screwdriver
- a flashlight
- Needle-nose pliers
- rubber gloves
- Make sure the drain stopper is removed. For those who cannot remove the stopper manually, you can use a screwdriver.
- You can use a flashlight to find the blockage.
- Pull the hair out with the needle-nose pliers while wearing your gloves.
- Try a wire hanger if the pliers cannot reach the clog or fit over the drain.
- Insert the wire hanger into the drain, fish around in the drain until you find a hair clump, and take it out.
- In order to clear the drain, use one liter of hot water to flush it out.
3. Use a Zip-it tool
The zip-it tool is made of a flexible, barbed, long piece of plastic that is intended for clearing drains.
The truth is that they are not so expensive, can either be re-used or thrown away, and are available at almost any hardware store.
- You simply need to insert the barbed end of the zip-it tool down into your drain, and you are ready to go.
- In this way, any hair that is caught in the drain will be pulled out with the zip-it as you pull it out.
- Most drain stoppers can be fit by Zip-it tool, but we recommend taking the stopper out anyway.
- Whenever you insert or remove the zip-it tool, twist or contort it in various directions.
- Afterwards, rinse the area well with hot water.
- After using a zip-it tool, I recommend using the baking soda and vinegar solution.
Think about buying some zip-it tools so that you can have them handy wherever you need them.
Finally, if you need to remove hair clumps in the future, you should be prepared for this task.
4. Plumbing Snake
Plumbers use a plumbing snake to clear clogs and break them up quickly. Also known as an auger, it is simply a flexible, long wire or plastic tool.
It’s available at any local hardware store if you don’t already have one. According to the purpose of the auger, there are a variety of sizes and styles available.
Here are a few things you need to consider when selecting an auger:
Design of the snake head
- The heads of plumbing snakes come in two different types: coil heads and cutting heads.
- You can remove clumps of hair from a drain with coil or toothed heads.
- Cutting heads are fitted with sharp blades that are capable of cutting through solid blockages.
Manual vs electric drain snakes
- The manual auger uses a snake that is pushed into the drain, turned to grab the obstruction, and then can be pulled out.
- There are electrical drain snakes that move the cable and retract it, just by pushing a button.
- This is one of the most practical solutions to get rid of major obstructions in pipes.
Dimensions of cable
- Augers usually come in a variety of standard thicknesses as well as a wide range of lengths.
- A cable that is at least 14% thick (25 feet in length) should be enough to unblock most showers, tubs, and sinks in the home and even in a rental property.
- A cable of 50 feet is most suitable for reaching clogs in longer pipes in multi-story homes with bathrooms upstairs.
- When you have a hair clog that isn’t too far from the drain and there isn’t too much soap buildup, you might be able to vacuum it out.
- You need an uncovered drain and a dry environment for successful results.
- You should plug up the top of the drain and suck out the contents by using a nozzle attachment on the highest setting.
- This method may be less effective because the obstruction may be farther down the pipe.
- However, it may be useful for removing any remnants after any one of the previous methods has been used.
There are many types of household tools that can be used for clearing blocked drains, but plungers are among the most common ones.
Plungers are available in a wide range of designs designed for different kinds of drains, so there is a plunger for every type of drain.
It is suggested to use a sink plunger or a standard plunger to resolve drainage issues with sinks, tubs, or showers.
A wooden or plastic handle is connected to a rubber cup on this type of plunger.
This type of cup is suitable for flat surfaces such as sinks and bathtubs.
In the following step-by-step guide, you will learn how to get hair out of sink drain using a plunger:
- The plunger should be placed over the drain.
- Make sure you fill the sink, bathtub, or the shower with enough water to submerge the plunger.
- Just keep pumping it up and down in rapid succession.
- Make sure the water drains away after removing the plunger from the drain opening.
- In case the water does not drain away, repeat the procedure.
- After the clog has been cleared, flush the drain with one liter of water to eliminate the leftover debris.
7. Remove entire drain
There are several tools required for this project such as a adjustable wrench, needle-nose pliers with a locking feature, flat-head screwdriver, gloves and standard pliers.
We will walk you through this process step-by-step, since it is more involved than the other tips listed above:
- Make sure that the stopper is removed.
- Plug wrenches should be inserted into drain openings and the ends should be fitted into the drain’s crossbars.
- Plug wrenches should be gripped with pliers or wrenches.
- After gripping the wrench, turn it counter-clockwise until the drain comes loose from the threading.
- The plug wrench should be removed after the drain is loosen and the needle-nose pliers inserted.
- As soon as your needle-nose pliers are clamped around the “X” bar in the drain, make sure they are locked in place.
- You may use conventional pliers or a wrench to hold the needle-nose pliers. Turn the needle-nose pliers counter clockwise using the pliers or wrench.
- The drain should now be sufficiently loose that you can pull it out fully by hand, once you have turned the needle-nose pliers.
Once the drain has been completely removed, you should thoroughly clean it in a sink or bucket.
If hair has gotten into any part of the mechanism, you must remove it before reinstalling the drain.
As a side benefit, this would also be a good time to replace an old drain with a more modern one.
If you want to find an exact replacement for the old drain, you are advised to take it with you to the hardware store.
8. Professional Plumber
- Whenever possible, try to resolve a hair clog yourself when possible but if that does not work, be sure to call a professional plumbers to take care of the problem.
- We use our advanced repair tools and technology to diagnose and resolve clogs caused by hair, soap scum, toilet paper, food and a wide array of other hard-to-remove items.
- No matter what you do, but do not use liquid drain cleaners.
- In addition to being ineffective, these types of products have potentially toxic chemicals that will wear out your pipes over time.
- Instead, use these methods to get hair out of the sink drain.
How to prevent hair from clogging the drain ?
In addition to being disgusting, removing clumps of hair from a drain takes time and is also quite tedious.
You could possibly spend several hundred dollars if you have to hire a plumber or purchase chemical drain cleaners in order to remove the hair from the drain.
Because of this, preventing clogs before they occur is the most effective strategy.
Here are a few ways to prevent hair from clogging the drain.
Brush your hair
- It is particularly recommended for individuals with long hair.
- It is helpful to brush your hair before bathing to prevent loose hair strands from falling out and being washed down the drain.
- It is advisable to brush your cat or dog prior to bathing them.
Fabric Softener Sheet
- Put a used fabric softener sheet over the drain opening to prevent clogging.
- Due to the sheet’s porous nature, hairs and debris will accumulate on its surface while water can pass through.
- After you take a shower, use a trash bag to discard the sheet.
Rinse With Hot Water
- Every week, you need to flush your drains with one liter of hot water.
- The warm water will disperse any grime that’s in your pipes and prevent the formation of hair clogs as well.
- An effective way to catch hair in the shower, tub, or bathroom sink drain is to use a kitchen strainer.
- In order for a strainer to work efficiently, it must have a wire mesh with tiny openings that trap hair, but still allow water to flow freely.
- You should remove and clean your strainer regularly to prevent accumulation of hairs.
We’re so excited to share this article with you today on how to get hair out of sink drain! We know that hair can get stuck in just about any sink, including kitchen sinks, bathroom sinks, and even utility sinks.
We also know that a clogged sink can be a real pain, so we hope that this article can help you avoid a clogged sink in the future.
We really appreciate you taking the time to read this article, and we hope that you can find some helpful information here.
If you have any questions or concerns about how to get hair out of sink drain, please don’t hesitate to contact us anytime.